11-28-2015, 01:31 PM
Hi there
I have just installed the software on the Pi, and have the Installer (Windows) connected. It is my understanding that Calaos should support MySensors. I have now attached the MySensor USB gateway to the pi. But where do I see the gateway in the Installer? It does not show up.
I would suppose that the gateway was automatically detected, and all sensors were shown. But I cannot see anything.
Do I have to do something special?
Br
Lemme
I have just installed the software on the Pi, and have the Installer (Windows) connected. It is my understanding that Calaos should support MySensors. I have now attached the MySensor USB gateway to the pi. But where do I see the gateway in the Installer? It does not show up.
I would suppose that the gateway was automatically detected, and all sensors were shown. But I cannot see anything.
Do I have to do something special?
Br
Lemme