01-19-2015, 06:07 PM
Hi,
I recently discovered this project and was thinking of using it for my domotic project.
I would like to use a messaging protocol to control a hardware board through calaos (think of mqtt/zeroMQ), but could only find the Wago PLC communication. Is it currently the only supported HW/communication protocol, or did I overlook that in the wiki?
My goal is to control some hardware boards I've made (I2C gpio expanders) with this frontend.
I'm an (embedded) SW engineer, so adding it myself wouldn't be that hard if it adds up to the project.
PS: is the forum/project/support french only?
I recently discovered this project and was thinking of using it for my domotic project.
I would like to use a messaging protocol to control a hardware board through calaos (think of mqtt/zeroMQ), but could only find the Wago PLC communication. Is it currently the only supported HW/communication protocol, or did I overlook that in the wiki?
My goal is to control some hardware boards I've made (I2C gpio expanders) with this frontend.
I'm an (embedded) SW engineer, so adding it myself wouldn't be that hard if it adds up to the project.
PS: is the forum/project/support french only?