Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
en:calaos_io_controller [2015/08/21 22:47] cleger [Bus] |
en:calaos_io_controller [2016/01/13 20:28] (current) |
||
---|---|---|---|
Line 3: | Line 3: | ||
Calaos IO is currently in design phase, and it's far to be complete. The following page aims to describes what Calaos IO will be. | Calaos IO is currently in design phase, and it's far to be complete. The following page aims to describes what Calaos IO will be. | ||
- | Calaos IO is a board designed to controlled | + | Calaos IO is a board designed to control |
The spectifications are the following : | The spectifications are the following : | ||
Line 20: | Line 20: | ||
LEDs indicator? | LEDs indicator? | ||
+ | Schematics can be found here : https:// | ||
==== Bus ==== | ==== Bus ==== | ||
Line 57: | Line 58: | ||
The frames will have the following format: | The frames will have the following format: | ||
- | {{:en:frame.png|Frame}} | + | {{:en:frame_cbp.png|Frame}} |
* Slave ID is a configurable id (through DIP switch or jumper) located on each sensors. | * Slave ID is a configurable id (through DIP switch or jumper) located on each sensors. | ||
Line 66: | Line 67: | ||
{{: | {{: | ||
+ | |||
+ | === Informations === | ||
+ | |||
+ | Schematic and prototyping code can be found at https:// | ||
+ | |||
+ | Application note for reading RS485 bus with STM32 processors : | ||
+ | |||
+ | http:// | ||
+ |