Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MySensors - does it work?
#1
Hi there
I have just installed the software on the Pi, and have the Installer (Windows) connected. It is my understanding that Calaos should support MySensors. I have now attached the MySensor USB gateway to the pi. But where do I see the gateway in the Installer? It does not show up.

I would suppose that the gateway was automatically detected, and all sensors were shown. But I cannot see anything.

Do I have to do something special?

Br
Lemme
Reply


Messages In This Thread
MySensors - does it work? - by Lemme - 11-28-2015, 01:31 PM
RE: MySensors - does it work? - by raoulh - 11-30-2015, 10:24 AM
RE: MySensors - does it work? - by Lemme - 11-30-2015, 02:34 PM
RE: MySensors - does it work? - by Lemme - 02-03-2016, 09:47 PM
RE: MySensors - does it work? - by raoulh - 02-04-2016, 09:44 AM
RE: MySensors - does it work? - by Lemme - 02-04-2016, 05:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)